Over-Center Spring, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
Release Bearing with Additional Plastic Washer
Identified by the tabs -arrow- on the plastic washer.
Only for Release Bearings with Additional Plastic Washer; Where
the Pressure Plate Diaphragm Springs -arrows- have a Slightly
Lower Installation Height.
• Install the release bearing with additional plastic washer and
the pressure plate diaphragm spring with a slightly lower in‐
stallation height.
1.5 Over-Center Spring, Removing and In‐
stalling
Removing
– Move the driver seat as far back as possible.
– Move the steering wheel upward as far as possible. Use the
entire steering column adjustment range.
Vehicles with a Knee Airbag
– Remove the driver side knee airbag -1-. Refer to ⇒ Body In‐
terior; Rep. Gr. 69 ; Knee Airbags; Overview - Knee Airbag .
Vehicles without Knee Airbag
Disconnect the battery ground cable. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 27 ; Battery; Battery, Disconnecting and Con‐
necting .
22
Rep. Gr.30 - Clutch