Volkswagen Golf 2015 Repair Manual page 56

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
Centering the Clutch Disc, Removing And Installing the Pressure
Plate on Engines with a Crankshaft with a Smaller Diameter, or
Engines with a Needle Bearing in the Crankshaft.
Note
Ignore arrows -A and B-.
Continuation for All
When Installing, Tighten Bolts as Follows So Pressure Plate Does
Not Distort (Causing Shuddering on Acceleration):
– Install the pressure plate on the centering pins.
– Install all bolts evenly, by hand, until the bolt heads touch the
clutch pressure plate.
– Tighten the bolt diagonally in small steps.
– Install the transmission. Refer to
⇒ 2.2 Transmission, Installing , page 92
Tightening Specifications
♦ Pressure plate on the flywheel. Refer to
⇒ 2.2.2 Overview - Clutch, with Dual Mass Flywheel, LuK ,
page 43 .
2.3.3 Clutch, Removing and Installing, with
Single Flywheel
Special tools and workshop equipment required
♦ Flywheel Retainer - 3067-
♦ Alignment Tool - Clutch Plate - T10097-
♦ Torque Wrench 5-50Nm - VAG1331-
♦ Clutch Disc Shaft Spline Lubricant - G 000 100-
Removing
• Transmission is removed.
– Insert the -3067- to loosen the bolts.
When Removing, Loosen the Bolts as Follows so that the Clutch
Pressure Plate Does Not Distort (Causing Shuddering on Accel‐
eration):
– Loosen all bolts clockwise one after the other in stages of 90°
until clutch pressure plate is free.
– Remove the pressure plate and the clutch plate.
52
Rep. Gr.30 - Clutch
.