Table of Contents
Advertisement
Mounting the MMS100 to a Projector
The alignment of the MMS100 mirror to the projector's optical path is critical for good performance. In addition, the
physical attachment of the MMS100 must be correct to not cause damage to the projector nor the fixture nor cause bodily
harm.
Key Points to note:
•
Visually inspect the structural integrity of the projector handling frame, as well as the MMS100 frame. If
either are damaged, do not continue.
•
Ensure that the (4) mounting clamps that are used to attach the MMS100 to the projector touring frame
are closed, locked, and tightened properly.
•
Ensure that the safety cable is firmly attached to the projector touring frame and the projector safety
point.
•
The alignment of the MMS100's mirror needs to be centered to optical lens path, adjust the physical
alignment of the MMS100's mirror to the projector frame first
•
The horizontal lens travel should be centered in its path, this will correspond to the center of the mirror
pan rotation.
•
The vertical lens travel should placed to minimize lens vignetting, while remaining as close as possible to
the lens rotation center.
•
It is critical that the mirror has good alignment to the optical path. This alignment is critical to the graphic
auto-rotation feature to work correctly.
•
When mounting to a Barco HDX, please take care of the Projector + MMS100, the balance of the
combined unit is slightly unstable.
Mounting to a Barco FLM (Un-mounted, Clamps open)
Advertisement
Table of Contents
