Table of Contents
Advertisement
B.2 System setup
Basic system configuration is set through the color CANtrak display
parameters. The display then broadcasts these settings to all the system
devices connected to the network.
Access the parameters by double-clicking on Main Color Display in the
Datalink workspace, then clicking on the Configuration tab. Remember to
click Write after making any changes.
B.2.1
System parameters
Figure B-2. Color display – System parameters.
Display station
Set the instance of the display. The default is Main; you only need to
change the second station display instance.
Set the appropriate system type from the drop-down list.
System Type
Number of Engines
At the time of printing only twin engine configurations are supported,
except on Yamaha DEC systems, for which triple-engine configurations are
supported.
Number of [component]
Enter the quantity of each listed component in your system.
RPM Source
Set to Electronic Engines.
Tachometer PPR
Not applicable
B-3
EN
Advertisement
Table of Contents
