Abbreviations - Dometic OPTIMUS 360 Installation Manual

vi

Abbreviations

The following abbreviations are used in this manual:
ABYC American Boat & Yacht Council
AUX Auxiliary
BAT Battery
BCM Boat Control Module (Suzuki)
CAN Controller Area Network
CAN bus Controller Area Network (data) bus. (A harness of
wires that carry digital signals and power between
electronic modules)
CL/CLP Command Link/Command Link Plus (Yamaha)
DC Direct current
DEC Digital Electronic Control (Yamaha)
ECM Engine control module
ENG Engine
EPS Electronic Power Steering
EST Electronic shift and throttle
FT-LB Foot-pounds, a US unit of torque
FWD Forward
GND Ground
HI High
IN-LB Inch-pounds, a US unit of torque
LED Light emitting diode
LO Low
LPS Lever position sensor
MPH Miles per hour
NA Not applicable or Not available
N/C No connection
Nm Newton-meters, a metric measure of torque
NMEA National Marine Electronics Association
A protocol for digital communication on a CAN Bus
NMEA 2000
®
OEM Original equipment manufacturer
PCM Pump control module
REV Reverse
ROT Rotation mode (joystick control)
RPM Revolutions per minute
SIDE Sideways mode (joystick control)
STBD Starboard (right when facing forward)
SW Switch
WOT Wide open throttle
NOTE
Some abbreviations not listed here may be found in their respective sections.
EN