Table of Contents
Advertisement
9-6
9.4 Honda IST/EST gateway setup
Before configuring the EST gateway you should have already conducted the
initial system setup described in section 4.
If you have more than one control station you will need to configure each
gateway separately, as they need to be calibrated to their adjacent remote
control. The calibration wizard records the output values from the remote
control's lever position sensors (LPS) at various lever positions.
The gateway calibration is performed easily with the CANtrak display.
Procedure
1. The gateway calibration must be performed with the engines keyed
on, but not running. Check the RPM reading on the color CANtrak.
The RPM value should be 0.
If the RPM displays as '---' on the CANtrak, check your speed source
connections.
2. At the main station CANtrak, navigate to Dealer Menu > Initial
Setup > EST Gateway to bring up the EST Gateway Setup screen. If
you have two gateways, and have correctly set the number of gateways
in section 4, then you will also see a 2nd station gateway on your screen.
Use cable ties to secure the harness cables to the strain relief plate as
shown in figure 9-5.
Figure 9-6.
EN
Advertisement
Table of Contents
