Dometic OPTIMUS 360 Installation Manual page 35

EN
3. A confirmation window similar to Figure 6-13 will be shown. Ensure the
information is correct, then click OK. Click Cancel to return to the
previous screen if you need to make a change.
4. The wizard will then guide you to trim each engine down in turn in
order to register their position in the boat control module (BCM).
Follow the on-screen instructions. An example is shown in Figure 6-14.
Figure 6-14. Registering the engine position
5. Once each engine's position has been registered you will be prompted
to calibrate the remote control lever positions. Using the main remote
control, follow the on-screen instructions as seen in Figure 6-15.
Figure 6-15. Control Head calibration.
6-11