Table of Contents
Advertisement
CAN2 CONNECTION
OF PCM OR ELECTRIC
ACTUATOR(S)
FEMALE
TERMINATOR
CM10052
Figure 3-2. Generic CAN2 wiring diagram.
EN
3.5 CAN2 Harness connections
The Optimus 360 system uses the same CAN2 network, cables and
structure as the basic Optimus EPS system. The Optimus 360 system adds
a joystick and control head (if applicable) to the CAN2 network.
Figure 3-2 shows a sample CAN2 network diagram. The exact connections
will vary depending on the engine manufacturer; consult the OEM-specific
sections of this manual for detailed network diagrams. Refer also to Book 50.1
or Book 54 for CAN2 wiring, harness selection, and installation best practices.
All tees must be secured using both screw holes, and the cable drops at
each tee must be appropriately secured and strain-relieved to prevent any
pull on the tees. See figure 3-3 for proper tee installation. Any unused tees
must either be capped or removed.
WARNING!
Failure to secure harness may result in harness wear, causing loss of
steering control, property damage, personal injury and/or death.
MALE
TERMINATOR
CM10051
JOYSTICK
DEVICENET
HARNESS
NETWORK TEES CM10060 OR
SIX-PORT HUB CM20064
NETWORK TEES CM10060 OR
SIX-PORT HUB CM20064
COLOR
CANtrak
4'
HARNESS
CM21504
3-5
Advertisement
Table of Contents
