Dometic OPTIMUS 360 Installation Manual page 5

EN
Appendix A - Mounting Templates ............................................ A-1
A.1 Joystick ......................................................................... A-1
A.2 Control head (Yanmar/Optimus) ..................................... A-3
Appendix B - Setup and Tuning with Datalink ........................... B-1
B.1 Using Datalink ............................................................... B-1
B.2 System setup ................................................................ B-3
B.2.1 System parameters ............................................. B-3
B.2.2 Settings menu access ......................................... B-4
B.2.3 Cycle power to system ........................................ B-4
B.3 Joystick tuning procedure ............................................... B-5
B.3.1 General notes .................................................... B-6
B.3.2 Before you start .................................................. B-6
B.3.3 STEP 1 - Import engine-specific settings ................ B-7
B.3.4 STEP 1a - System ................................................ B-7
B.3.5 STEP 2 - Set throttle limits .................................... B-7
B.3.6 STEP 3 - Run throttle wizards ............................... B-9
B.3.7 STEP 4 - Set forward heading correction .............. B-10
B.3.8 STEP 5 - Balance rotation power .......................... B-11
B.3.9 STEP 6 - Set sideways rudder angle ..................... B-12
B.3.10 STEP 7 - Balance sideways engine power ............. B-13
B.3.11 STEP 8 - Adjust power levels .............................. B-14
B.3.12 STEP 9 - Sea trial ............................................... B-15
B.3.13 STEP 10 - Saving the joystick tuning file ................ B-15
B.4 Adding a second control station .................................... B-16
B.4.1 Configure the secondary helm and
CANtrak display ................................................ B-16
B.4.2 Configure the secondary control head
Yanmar only) ..................................................... B-16
B.4.3 Configure the secondary joystick ........................ B-16
B.5 Importing a joystick tuning file ....................................... B-17
B.5.1 Configuring a second joystick ............................. B-17
B.5.2 Using a template file .......................................... B-17
B.5.3 Replacing a joystick ........................................... B-18
B.5.4 Updating joystick firmware ................................. B-18
B.5.5 Basic import procedure ..................................... B-18
B.6 Yamaha EST gateway setup ........................................... B-20
B.6.1 System ............................................................. B-21
B.6.2 LPS calibration .................................................. B-21
v