Table of Contents
Advertisement
Figure B-24. Sample of final calibration values.
EN
4. The Calibration Step field will change to 'Forward Detent.' Move the
levers to the correct position, and when the Calibration Step Status
reads 'Ready,' click Save Calibration Point.
5. Continue in this manner through each lever position shown in the
Calibration Step field.
6. Once you've calibrated the last lever position, click Read and the LPS
Calibration Values table will populate with the calibrated values (see
figure B-24). The LPS Calibration Status field will now read 'Calibrated'
to indicate that calibration is complete.
You are now ready to sea trial the steering system. Refer to Book 50.1 or
Book 54. When the sea trial is complete, proceed to the joystick
setup in section 9 of this manual.
TECH TIP
B-23
Advertisement
Table of Contents
