Table of Contents
Advertisement
PUBLIC N2K
DEVICES
CM100XX
12V
PORT
ENGINE
STBD
ENGINE
Figure 11-1.
EN
11 OXE
To complete the system installation for an OXE EST engine you need to:
1. Install the OXE control head (refer to installation instructions provided
by OXE)
2. Complete the CAN network connections (11.1)
11.1 OXE and Optimus 360 network
interconnection
The OXE shift and throttle system and Optimus 360 system connect
together through the CAN2 network. CAN3 is used to broadcast system
information to a public NMEA2000 network.
1. CAN2 connects to the OXE E-CAN network. This network should
already be adequately terminated with two terminating resistors. Do
not add more terminating resistors.
2. CAN3 connects to the NMEA2000 instrumentation network.
3. PCM ignition is connected to the key-on ignition switch panel.
Complete the CAN network as shown in figure 11-1.
CM20503
CM204XX
PCM
TERMINATOR
CM10051
Setup the system as instructed in Book 65. When prompted to select a
Shift and Throttle type, select i7700.
IGNITION
CM20406
72" HARNESS
COLOR
HELM 1
JOYSTICK 1
CANtrak 1
OXE
ENGINE
DISPLAY
CM100XX
SEASTATION
/SEAWAY
SENSOR
PURPLE x 2
CONTROL
HEAD 1
P S
RUN
OFF
IGNITION
SWITCH PANEL
TERMINATOR
CM10052
OXE E-CAN
CAN1 FTCAN PRIVATE NETWORK
CAN2 PRIVATE NETWORK
CAN3 PUBLIC N2K NETWORK
11-1
Advertisement
Table of Contents
