Table of Contents
Advertisement
CAN2 PORT
(SEE SECTION 3.5)
HARNESSES MUST
BE STRAIN RELIEVED
TO JOYSTICK
MOUNTING STUD
USING CABLE TIES
PROVIDED
CANtrak
Figure 3-1. CAN1 harness connections.
3-4
3.4 CAN1 Harness connections
For CAN1 harness selection and connections refer to the Optimus EPS
Installation Manual (Book 50.1) or Optimus EPS Electronic Power Steering
with Electric Actuator Installation and User's Manual (Book 54).
In addition to this, the Optimus 360 system requires a 6-pin CAN1 harness
connection between the steering helm and the joystick. Refer to Book 50.1
or Book 54 for proper harness selection and strain relieving.
In particular installations, a CAN1 wye harness (CM21702) or a CAN1 hub
(HA5497) may be required to make all necessary connections.
JOYSTICK
CAN1 HARNESS
TO HELM
HARNESS MUST BE
STRAIN RELIEVED TO HELM
HOUSING TAB USING
CABLE TIES PROVIDED
TO CAN2
NETWORK
NODE
CM21504 HARNESS
HARNESS TIE POINT X 4
ELECTRONIC
HELM
CAN1 HARNESS TO
PCM OR ELECTRIC
ACTUATOR
EN
Advertisement
Table of Contents
