EN
3.3 Installing the Joystick
Install the joystick on the dash in an area that allows convenient,
unobstructed access. Whenever possible, mount the joystick on a
horizontal surface in a location that will minimize water spray.
Install the joystick using the hardware provided in the kit. The joystick
harnesses must be strain relieved to one of the mounting studs using the
cable tie provided with the joystick hardware.
A dash cutout template is provided in Appendix A.
3.3.1
Joystick types
There are two types of joysticks: master and additional station. Every
installation must have at least one master joystick, which comes factory
configured for the number of engines in the installation. The master joystick
can be installed at any control station – the joystick type is independent of
the joystick station.
If there is no master joystick in the system you will get a persistent "Missing
Master Joystick" warning on the CANtrak display. Similarly, if the master
joystick type doesn't match the configured number of engines, the
CANtrak will display a persistent "Invalid Joystick Configuration" warning.
Table 3-3 lists the available joysticks at the time of printing.
Joystick Part No. Description
EJ1400
EJ1403
EJ1404
EJ1401
Table 33. Available Joysticks.
Joystick, Master, Twin Engine
Joystick, Master, Triple Engine, Tiebar
Joystick, Master, Quad Engine, Tiebar
Joystick, Additional Station
3-3