Table of Contents
Advertisement
6-8
Splice one of the ignition sensing wires to the purple switch power wire on
the CM20018 harness (see figure 6-7) using 16AWG (1.3 mm2) wire to make
any necessary extensions. Use crimped Molex Perma-Seal (or equivalent)
butt splice connectors, or shrink-sealed solder connections. Locate all splices
in a dry location and secure them properly against mechanical damage.
Connect the second purple ignition sensing wire to the gray troll switch
power wire on the Suzuki switch panel harness (see figure 6-7). The troll
switch wire is supplied with a crimped female bullet connector, sealed with
a black plastic plug. A mating bullet connector is included in the bag with
the CM20018 harness. Crimp it to your ignition extension wire, then simply
push the male connector bullet into the female receptacle to complete the
connection (see figure 6-9). If required, additional bullet connectors can be
ordered through a Suzuki distributor, using Suzuki part number 36990-87D00.
If the vessel is fitted with a Suzuki troll mode switch the troll switch wire will
already be connected. In this case, the troll switch harness has an alternate
point to connect the ignition. Look for the female bullet connector with
two gray wires crimped into it.
FEMALE CONNECTOR
Figure 6-9. Male and female bullet connector.
6.3 Suzuki SPC system calibration
NOTICE!
Suzuki twin and triple-engine applications are a single network configuration
and need to be calibrated using the SDS tool.
Suzuki quad applications are a 2 network configuration and need to be
calibrated using the SDS tool twice — Once for the port engine pair
and once for the starboard engine pair.
The Suzuki SPC system must be configured and calibrated in order to work
with the Optimus joystick system. To calibrate the system you will need the
Suzuki Diagnostic System (SDS) tool and the Suzuki diagnostic interface
adapter (Suzuki part number 09933-19830). Connect the interface adapter
and start the software according to the instructions provided by Suzuki.
CRIMP MALE BULLET
PER MANUFACTURER'S
INSTRUCTIONS
EN
Advertisement
Table of Contents
