Table of Contents
Advertisement
EN
4 System Setup, Purge,
and Calibration
Before you proceed you need to have all Optimus EPS and Optimus 360
components installed, harnesses connected, and ignition sensing and
power wiring completed. If you haven't already done so you'll need to go
to the section specific to your engine (section 5 through section 11) for
network interconnection diagrams and some engine-specific installation
details. Do not do any engine-specific setup or configuration at this time;
you will need to perform the initial setup first.
4.1 Initial system setup
The system setup is performed easily with the color CANtrak display. (If you
prefer to use Datalink, see Appendix B.) It is designed to walk you through
the following tasks:
• Configure the system type
• Choose the number of helms and displays in your system
• Update system software
• Select device locations
You will need access to the CANtrak Dealer Menu for all setup tasks. See
section 2.1 in the Optimus EPS Installation Manual (Book 65) for instructions.
NOTICE!
The software update wizard uses the system configuration you set up here
to automatically install the correct software revisions for your system. Don't
update the software until prompted in the procedure.
Procedure:
1. On the display, navigate to Dealer Menu > Initial Setup > System
to access the System Setup menu.
Figure 4-1.
4-1
Advertisement
Table of Contents
