Table of Contents
Advertisement
7-2
4. Remove the control head from the dash far enough to expose the cover
mounting screws. (Refer to figure 7-2. Port side is shown.) Both sides
will need to be removed, but it is recommended that you proceed
with one side at a time. Be sure to support the control head so that the
harnesses are not under strain.
5. Cut the cable tie securing the harnesses to the binnacle chassis.
(Refer to figure 7-2.)
6. Disconnect the Yamaha LPS harness. The port harness will be identified
with a 'P' and the starboard harness will be identified with an 'S'. (Refer
to figure 7-2.) Triples and quads: There will be harnesses labeled CP
and/or CS. You will not use these harnesses for a triple, but you will
need to connect them for a quad. Disconnect only one harness at a
time. The connectors are only labeled on one end, and it is very easy
to mix them up if both are disconnected.
7. Connect the EST gateway harness as shown in figure 7-3. Port harness is
identified 'P_LPS' and the starboard harness is identified 'S_LPS.'
BINNACLE COVER
CONTROL HEAD
BINNACLE
Figure 7-1. Control Head Binnacle removal.
SCREW x 2
SCREW x 4
DASH
EN
Advertisement
Table of Contents
