Table of Contents
Advertisement
EN
Figure 8-6. Harness connection to EST gateway.
8.3 Mercury DTS/EST gateway setup
Before configuring the EST gateway you should have already conducted the
initial system setup described in section 4.
If you have more than one control station you will need to configure each
gateway separately, as they need to be calibrated to their adjacent remote
control. The calibration wizard records the output values from the remote
control's lever position sensors (LPS) at various lever positions.
The gateway calibration is performed easily with the CANtrak display.
Procedure
1. The gateway calibration must be performed with the engines keyed
on, but not running. Check the RPM reading on the color CANtrak.
The RPM value should be 0.
If the RPM displays as '---' on the CANtrak, check your speed source
connections. Take note that it can take 45 seconds for a Mercury DTS
system to start broadcasting engine speed signals.
CABLE TIE
GATEWAY HARNESS
PART NO. CM20038
CM20038
HARNESS
CABLE TIE
8-5
Advertisement
Table of Contents
