Installation Checklist; Hardware Installation; Cable Routing And Connection - Graco Horizon Fluid Management Systems Instructions Manual

Table of Contents

NOTE:

D After completing the Pre-installation Checklist on page 6, use the following installation checklist to guide you

through the steps of the system installation.

D Refer also to Installation and Troubleshooting Tips, beginning on page 61, for information that will help you

avoid installation problems and correct any problems that may occur.

Hardware Installation

Installation Steps

1. Flush all fluid lines to remove the debris and avoid clogs in the meters.

2. Install the solenoids and meters in the fluid and air systems.

3. Set the control module addresses with the DIP switches and label each

control module.

4. If the electrical input is 220 VAC, rewire the transformer.

5. Mount each control module and keypad bracket in its assigned location.

Cable Routing and Connection

Installation Steps

6. Route and connect the AC power to each control module. Do not turn on

the power yet!

7. Route the solenoid and meter cables to their assigned control module.

8. Connect each solenoid and meter cable to the proper connector/port in the

assigned control module.

CAUTION:

will be damaged.

9. Route the CAN network cable between the control modules. Connect the

cable to the proper control module connectors. Remove the terminating

resistor from the connectors of the control modules that are in the middle of

the network chain.

10. Route and connect the keypad cables between the keypads and the control

modules.

11. Route and connect the printer or computer cable between the Master Control

Module and the printer or computer.

12. Visually check that all wiring is connected correctly. Compare the wiring to the

diagrams in this manual.

308607