Dispense Request - Graco Horizon Fluid Management Systems Instructions Manual

Instructions

3. Dispense Request

NOTE:
D Only valid dispense areas for the selected fluid are
accepted as an entry.
D If an invalid fluid or dispense area number was
entered, a RUN ERROR screen will appear. Press-
ing any key will return the screen to the previous
valid screen.
D If there is only one valid dispense area in the sys-
tem (such as for a lube truck), steps 3d. to 3f. will
be omitted.
a.. Cursor is in the select fluid number field
(SEL FL). 01 is the default fluid. The fluid name
(PENNZ 10W30) is displayed after the fluid
number.
b.. Display the fluid to be dispensed either by en-
tering the fluid number or by pressing the " or
# key to scroll through the options.
c.. Press ENTER on the keypad to select the fluid.
d.. Cursor moves to the dispense area number
field (SEL DA).
e.. Type in the number for the desired dispense
area or press the " or # key to scroll through
the options.
f.. Press ENTER on the keypad.
g.. Dispense area name will display, following dis-
pense area number.
a. To select a preset dispense, follow step 4. To
select a free flow dispense, follow step 5.
50 308607
Run Mode - - New Job
Screens
DISPENSE REQUEST Screens
SEL FL:01 PENNZ10W30
SEL DA:01 BAY1
SEL FL:02 PENNZ5W20
SEL DA:03 BAY3
RUN ERROR Screen for Invalid Fluid
RUN ERROR:
INVALID FLUID
USE ANY KEY TO CONT.