Fluids - Graco Horizon Fluid Management Systems Instructions Manual

Instructions
Enter Fluid Data
1. Cursor is in the fluid number (FL01) field.
2. The fluid number will automatically increment up
by 1 as you add fluids or you can type the number
identification of the fluid.
3. Press ENTER on the keypad.
4. Cursor moves to the NAME field.
5. Type the name of the fluid.
6. Press ENTER on the keypad.
7. Cursor moves to the UNITS field.
8. Scroll through the available units of measurement
by pressing the # or " key, and stop at the value
needed.
There are four units of measurement available:
quarts, liters, gallons, and pints.
9. Press ENTER on the keypad.
10. Cursor moves to ORDER number field. The order
number determines the order that fluids are dis-
played during RUN operations. The default setting
is to display the fluids in the order of the fluid
numbers.
11. Type in the order number if it is different than the
number displayed.
12. Press ENTER on the keypad.
13. Cursor moves to ADD.
14. Press ENTER to repeat the screen and add anoth-
er fluid.
-- Or move the cursor to DELETE to delete the fluid
entry that is displayed.
-- Or move the cursor to EXIT to exit the fluid
setup.
Save the Setup
Follow the Save Setup procedure on page 30.
32 308607
System Setup - - Fluids
Screens
FLO1 NAME:
UNITS: QUARTS
ORDER: 01
ADD EXIT
FLO1 NAME:
UNITS: QUARTS
ORDER: 01
ADD EXIT
FLO1 NAME: 10W30
UNITS: QUARTS
ORDER: 01
ADD EXIT
FLO1 NAME: 10W30
UNITS: QUARTS
ORDER: 01
ADD EXIT
FLO1 NAME: 10W30
UNITS: QUARTS
ORDER: 01
ADD EXIT
# "
DELETE
# "
DELETE
# "
DELETE
# "
DELETE
# "
DELETE