Route Solenoid And Meter Cables; Connect Solenoid And Meter - Graco Horizon Fluid Management Systems Instructions Manual

Cable Routing and Connection
7. Route the Solenoid and Meter Cables
to their Assigned Control Module
8. Connect the Solenoid and Meter
Cables
f. Connect the solenoid cables as shown in Fig.
6. The cables connect at the solenoid end with
wire nuts.
g. Connect the Ready Light as shown in Fig. 6.
h. Connect the pulse meter cables. The cables
connect at the pulse meter end with wire nuts.
Connect an oil meter as shown in Fig. 7.
D
Connect an anti-freeze meter as shown in
D
Fig. 8. Be sure to install the RC Filter.
NOTE: See Fig. 9, page 16, for connector locations.
Pulse Meter P/N 238618 Connection
Connector J5 in this drawing; can be J5, J6, or J7
¡
© Use bulk Cable P/N 113555 (500 ft. [152.5 m]) or
113556 (1000 ft. [305 m)]); 50 ft. (15.3 m) maxi-
mum length
¢ Pulse Meter P/N 238618
Fig. 7
Pulse Meter P/N 215474 Connection
¡ Connector J5 in this drawing; can be J5, J6, or J7
© RC Filter P/N 113837; included with meter
Pulse Meter P/N 215474
¢
NC=No Connection
red
¢
black
Fig. 8
red
white
¢
black
N/C
signal
ground
Solenoid Connection
P8 or P9
¡
Use bulk Cable P/N 113557 (500 ft. [152.5 m]) or 113558
¡
(1000 ft. [305 m)]); 50 ft. (15.3 m) maximum length
© Ready Light Kit 238996
NOTE: If existing Ready Light is used, the bulb and lens must
be replaced with bulb P/N 113859 and lens 113857
¢ Fluid Solenoid P/N 218588 (includes Ready Light), 215487 or
512927; Air Solenoid P/N 215407 or 512926
Fig. 6
red
white
black
+12V
+12V
signal
signal
ground
ground
shield
©
N/C
signal
ground
shield
©
¡
+12V
P5
J5
signal
ground
shield
Circuit Board
¡
P5
©
N/C
red
black
308607
¢
06577
06579
06580
15