Dispense Areas - Graco Horizon Fluid Management Systems Instructions Manual

System Setup - - Dispense Areas
Instructions
Define Dispense Areas
1. Cursor is in the dispense area number (DA01)
field.
2. The dispense area number will automatically
increment up by 1 as you add areas or you can
type the number identification of the area.
3. Press ENTER on the keypad.
4. Cursor moves to the NAME field.
5. Type the name of the dispense area.
6. Press ENTER on the keypad.
7. Cursor moves to the first N in line three.
The fluid numbers will be displayed according to
the number of fluids that were entered while Enter-
ing the Fluid Data (shown on previous page). In
this example, 6 fluids were entered.
8. Leave the N if fluid #1 is not available at this dis-
pense area. Scroll to Y by pressing the # or " key if
the fluid is available at this dispense area.
9. Press ENTER on the keypad to ENTER the value
and move to the next N.
10. Repeat step 8 and 9 until all the Y/N values are
entered and the cursor moves to ADD.
11. Press ENTER to repeat the screen and add anoth-
er dispense area.
-- Or move the cursor to DELETE to delete the
dispense area that is displayed.
-- Or move the cursor to EXIT to exit the dispense
area setup.
Save the Setup
Follow the Save Setup procedure on page 30.
Screens
DAO1 NAME:
1 2 3 4 5 6
N N N N N N
ADD EXIT
DAO1 NAME:
1 2 3 4 5 6
N N N N N N
ADD EXIT
DAO1 NAME: BAY 1
1 2 3 4 5 6
N N N N N N
ADD EXIT
DAO1 NAME: BAY 1
1 2 3 4 5 6
Y Y Y N N Y
ADD EXIT
DELETE
DELETE
DELETE
DELETE
308607 33