Types Of Setup - Graco Horizon Fluid Management Systems Instructions Manual

Instructions

Types of Setup

1. SETUP screen appears.
2. Cursor is on ENABLE/DISABLE CAN.
3. Move the cursor by pressing the " or # key.
4. Press ENTER on the keypad when the cursor is at
the desired selection.
ENABLE/DISABLE CAN: ENABLE CAN is the default
selection. It indicates that the system has more than
one control module. For normal operation, all control
modules should have CAN enabled. To change to
DISABLE CAN, which must be done for a system with
only one control module, follow page 21.
NOTE: When a controller's CAN communication is
disabled, the controller will not send any CAN mes-
sages but it can still receive CAN messages.
MODIFY SETUP: to modify a current setup. See page
22.
NEW SETUP: to enter a completely new setup. See
page 22.
CLEAR SETUP: to clear particular setup options.
Choose CLEAR SETUP if this is the initial setup of a
new system. See page 23.
PRINT SETUP: to print out selected information about
the control module. If this is the initial setup of a new
system, print out ALL MEMORY after the system is
completely installed, for future reference. See page 24.
UPDATE TABLES: to send information from one
control module to all connected control modules. If the
Master Control Module was setup off-line, use this
feature to send information to all control modules after
they are connected. See page 25.
DIAGNOSTICS: to help troubleshoot the system. See
page 26.
20 308607
System Setup - - Startup
Screens
SETUP Screens
_ _ _ _ _ _ _ _ _ _" SETUP A_ _ _ _ _ _ _ _ _ _
ENABLE/DISABLE CAN
MODIFY SETUP
NEW SETUP
_ _ _ _ _ _ _ _ _ _" SETUP A_ _ _ _ _ _ _ _ _ _
CLEAR SETUP
PRINT SETUP
UPDATE TABLES
_ _ _ _ _ _ _ _ _ _" SETUP A_ _ _ _ _ _ _ _ _ _
PRINT SETUP
UPDATE TABLES
DIAGNOSTICS
#
"
#
"