Computer: Receiving Horizon Data; Windows 3.1 Setup - Graco Horizon Fluid Management Systems Instructions Manual

Computer: Receiving Horizon Data

Windows 3.1
The following instructions are for use with computers
running Windows 3.1.
Terminal Program Setup
Follow these steps to provide the terminal program
with the settings needed to receive Horizon data. Once
these settings are saved, they do not have to be set
and saved again, just load the HORIZON.TRM file
each time the terminal program is started up.
1. Open Accessories in your Program Manager.
2. Open Terminal.
3. Pull down the Settings menu and select Commu-
nications.
4. Set as shown below (Baud Rate--9600, Data
Bits--8, Stop Bits--1, Parity--None, Flow Control--
None, Connector--COM1), then select OK.
5. Pull down the terminal File menu and select Save
As.
6. Type in the desired File Name
(example: HORIZON.TRM).
7. Make sure the Save Files of Type is set to Termi-
nal Files (*.TRM).
8. Select the desired Drive and Directory where you
want the Horizon terminal definition to be saved.
9. Select OK.
308607 43