Important; Control Modules; Name Master Control Module; Name Slave Control Modules - Graco Horizon Fluid Management Systems Instructions Manual

System Setup - - Important!
In order for the system to operate properly, the follow-
ing guidelines must be followed when entering the
following setup information:
D Fill out the name fields completely.
System Setup - - Control Modules
Instructions
Name the Master Control Module
1. Cursor is in the NAME field.
2. Type the name of the control module location
(maximum of 10 characters).
3. Press ENTER on the keypad.
4. Cursor moves to ADD.
5. Press ENTER to add another control module.

Name Slave Control Modules

1. Cursor is in the CM# field.
2. The control module number will automatically
increment up by 1 as you add modules or you can
type the number identification.
NOTE: The control module number must corre-
spond with the numbers setup on the control mod-
ule DIP switch.
3. Press ENTER on the keypad.
4. Cursor moves to the NAME field.
5. Type the name of the control module location.
6. Press ENTER on the keypad.
7. Cursor moves to ADD.
8. Press ENTER to add another control module.
-- Or move the cursor to DELETE to delete the
control module entry that is displayed.
-- Or move the cursor to EXIT to exit the control
module setup.
Save the Setup
Follow the Save Setup procedure on page 30.
D Complete the setup tables in the order they appear
as information in consecutive screens is dependant
on information entered in previous screens.
Screens
NAME CONTROL MODULES
CM#01 (MASTER CM)
NAME:
ADD EXIT
NAME CONTROL MODULES
CM#02 (SLAVE CM)
NAME:
ADD EXIT
NAME CONTROL MODULES
CM#02 (SLAVE CM)
NAME:
ADD EXIT
DELETE
DELETE
308607 31