General Safety Information - PRONOVA SSM 6000 User Manual

SSM 6000
CONT

General safety information

The following safety information must always be observed during operation as well as during any maintenance and repair work on
this device. Non-compliance with safety measures or any other information or warnings contained in this user manual constitutes a
violation of safety standards underlying the design, manufacture and proper use of the device.
Non-compliance with such information can cause hazards for users and/or damage to the device! The manufacturer does not accept
any liability for losses or damage caused by non-compliance with such safety measures on the part of the customer.
In order to avoid any additional hazards, unauthorized modification of the device is not permitted. In the event that repair work is
necessary, the device should be returned to our technical office after prior notification.
Users are not permitted to open the device. Certain activities – such as replacing hardware components or internal settings – may
only be carried out by qualified personnel.
Devices which are suspected to be at fault or defective must be switched off and protected against unauthorized access until the
necessary repair/service work has been performed by expert personnel.
When working in explosive or flammable environments, do not operate the device without additional protection measures!
Proceed in accordance with the safety instructions applicable to the respective gases and calibration gas bottles or
cylinders!
Prior to performing any work on gas ducts or pipes, flush these with ambient air or nitrogen (N
hazard due to toxic, explosive, flammable or harmful components of the measuring gas.
When connecting the device, make sure that the correct mains voltage is available, and proceed in accordance with the information
in the section titled "Requirements for the place of installation, power supply".
The analyzer is a safety-class 1 device, i.e. it is fitted with an earthing connection. Any interruption of the PE conductor inside or
outside the device, or opening of the PE connection can make the device a hazard. Deliberate interruption of the PE conductor is not
permitted.
The device comes with a power cable with earthed-contact plug and may only be connected to an earthed-contact receptacle. The
protective effect may not be rendered ineffective by using an extension cable without PE conductor.
Before performing any fault-finding or repair work, or before replacing any parts, disconnect the device from any voltage
sources! In the event that work must be performed on the live, opened device, this may only be carried out by an informed
expert who must be familiar with the related risks and hazards!
800C-07.07.EN SSM 6000C User Manual
GENERAL SAFETY INFORMATION
) in order to avoid any
2
9