PRONOVA SSM 6000 User Manual page 27

SSM 6000
CONT
Fitting the power cable using QUICKON
QUICKON components
1 Union nut
2 Crown
3 Rubber seal
4 Splice ring
5 Contact support
1. Remove power cable
Open screw connection.
-
Pull the cable in order to separate the wires from the terminals.
-
Remove residues of insulating material before re-connecting.
-
2.. Preparation and installation
Strip a section of around 15mm of the cable sheath.
-
Assemble union nut, crown and rubber seal.
-
3. Install QUICKON components
Push wire ends into the openings of the splice ring. In order to
-
ensure correct assignment, the conductors are marked with numbers
and may not be interchanged!
Identification of the individual conductors:
-
1 N
2 L
3 PE
Cut off excess wire ends (the wire ends may not project from the
-
splice ring by more than 2mm).
4. Tighten
Insert the prepared cable into the contact support.
-
Tighten the union nut. During tightening, QUICKON automatically
-
establishes the contact and the strain relief function.
Re-connecting the power cable
Cut off wire ends approx. 20mm.
-
Erneute Montage wie zuvor beschrieben.
-
800C-07.07.EN
(neutral) blue
(phase) brown
(protective earth) green/yellow
SSM 6000C User Manual
HARDWARE INSTALLATION
27