Table of Contents
Advertisement
SSM 6000
CONT
** In the case of an excess pressure of more than 5 hPa at the measuring-gas inlet of measuring point 1, the customer is
responsible for installing a stop valve in order to close the measuring-gas inlet during longer measuring breaks. An automatic
stop valve is also optionally offered by the manufacturer and directly integrated into the measuring-gas inlet of the analyzer.
The measuring-gas inlets of measuring points 2 to 4 are automatically closed during measuring breaks and when the analyzer is
switched off, and hence do not require an additional shut-off device.
Corrosive gases
Calibration gases for calibration
3.3
Scope of delivery, rating plate and test certificates
Scope of delivery
Identification plate
Test and calibration
certificate
800C-07.07.EN
The gas analyzer may not be used to measure corrosive gases. Certain gases, such as
chlorine (Cl
) or hydrogen chlorides (such as moist HCl), and chlorine-containing gases
2
or aerosols must be cooled or pre-absorbed.
For information concerning the calibration gases for calibrating the gas analyzer, please
refer to the "Calibration" section.
Quantity Description
1
SSM 6000 gas analyzer
1
Setup key
1
Housing key
20 m
PVC hose 4x1mm (plus an additional 10m per measuring point with the measuring-point
switch option)
2
Replacement fuse for SSM 6000 (miniature fuse, 1A slow-blow, 4x20mm)
1
Data cable for RS232 interface (length: 3m)
1
User manual (German or English)
1
CD-ROM with operating manually (pdf format) with gsd file for Profibus connection
1
Test and calibration certificate of the SSM 6000 analyzer
SSM 6000 (B)
CONT
CH
/ H
S / O
/ CO
4
2
2
2
S No.:
80025000 - 375
Mains:
230 VAC / 50 Hz
85 VA max.
The test and calibration certificate contains the following information
• Manufacturing and serial number
• Measuring components and options
• Software version
• Calibration and result of test measurements
• Result of the function test
• Test result, including test date
SSM 6000C User Manual
The rating plate is located on the underside and on the door of the
device.
It contains the following information:
Analyzer identification
-
Measuring components
-
Manufacturing and serial number
-
Power supply voltage, frequency and power consumption
-
HARDWARE INSTALLATION
23
Advertisement
Chapters
Table of Contents
