Display And Control Panel - PRONOVA SSM 6000 User Manual

SSM 6000
CONT
2.2.2

Display and control panel

The measured values are displayed for each gas type on the four-digit LED panels in the respective unit (Vol.% and ppm,
respectively). In the case of devices with reduced functionality, the displays of gas types not included in the functionality remain
inactive.
The status LEDs next to the measured values represent the status of the respective gas channel.
active (green) This gas type is currently being measured.
stand-by (yellow) The device is ready for operation, but the gas type in question in currently not being measured.
alarm (red) The last value measured was outside the set limits and hence triggered an alarm.
Settings and operating parameters of the analyzer can be entered and changed via the control panel. The user menus are displayed
on the four-line, backlit LC display.
Navigation through the user menus is possible in setup mode via the membrane keypad (esc, up, down, enter). The setup mode is
activated via the key-operated switch. Withdrawing the access key prevents changes in analyzer settings by unauthorized persons.
The analyzer is switched on and off via the "power" button.
800C-07.07.EN
Status LEDs
Measured values
SSM 6000C User Manual
LC display
Membrane keypad
Setup switch
HARDWARE DESCRIPTION
Power switch
16