Connecting The Gas Pipes - PRONOVA SSM 6000 User Manual

SSM 6000
CONT
CAN interface (option)
The CAN interface for the output of measured data via a CAN bus system is not yet supported by the software in its current version.
Connector module at the analyzer:
3.5.3

Connecting the gas pipes

All gas connections are located on the underside of the analyzer. The connections are clearly marked and may not be exchanged.
The gas-carrying pipes are connected to the device by means of clamping-ring screw connections.
The following connections must be made:
The delivery includes 20 meters of PVC hose (an additional 10m per measuring point with the measuring-point switch option) and
the required connections.
Fig.: Analyzer view from below
In order to connect the gas pipes and hoses, proceed as follows:
Connecting the gas pipes
800C-07.07.EN
D-sub 9-pole, plug connector
- 1x Measuring gas in / 2 .. 4x (with measuring-point switch option)
- 2x Measuring gas out
- 1x Condensate out
Step Action
1 Cut hose at a right angle.
2 Push knurled nut and clamping ring over the end of the hose.
3 Push the end of the hose fully onto the sleeve.
4 Screw on the knurled nut and tighten by hand.
SSM 6000C User Manual
HARDWARE INSTALLATION
29