Hardware Description; Measuring Characteristics; Elements Of The Analyzer - PRONOVA SSM 6000 User Manual

SSM 6000
CONT

2 HARDWARE DESCRIPTION

2.1

Measuring characteristics

The SSM 6000 Continuous analyzer was developed for the continuous measurement of CH
determination of H S and H
2 2
Gas type Measuring range
0 ... 100
CH
4
0 ... 5.000
H S
2
0 ... 1.000
H 0 ... 1.000
2
0 ... 25
O
2
0 ... 100
CO
2
* The H S measuring range depends on the analyzer version. H
2
The following sections deal with operation, calibration and menu structure of the analyzer.
2.2

Elements of the analyzer

800C-07.07.EN
concentrations in biogenic gases. The table below contains details concerning measuring ranges, etc.
Resolution
0,1 Vol.%.
Vol.%.
ppm 1 / 5 ppm
ppm 1 ppm
ppm 1 ppm
Vol.%. 0,1 Vol.%.
Vol.%. 0,1 Vol.%.
SSM 6000C User Manual
Precision Measuring method Other
±2% FS Two-beam IR
±5% FS Electrochemical
±5% FS Electrochemical
±5% FS Electrochemical
±2% FS Electrochemical
±2% FS Two-beam IR
S and H measurement is carried out as a discontinuous process.
2 2
The front panel of the analyzer contains all the
controls necessary for operation:
1 Control and display panel
2 Aerosol filter
3 Air filter
4 Chemical filter
5 Fine dust filter
6 Flowmeter
7 Needle valves
8 Measuring-gas input with detonation protection
9 Measuring-gas outputs
10 Screw-type cable connection with power cable
11 Interfaces
12 Wall-mount support
13 Status display LEDs for measuring-gas cooler
14 Condensate pump
15 Condensate output
16 Ventilation air inlet
17 Ventilation air outlet
All electrical connections and gas connections are
located on the underside of the device.
Fig.: Front view of the analyzer
HARDWARE DESCRIPTION
, O , CO and for the discontinuous
4 2 2
Temperature and pressure compensation
Dilution stages 1:200/40/10/0
Without Dilution
Without Dilution (instead of H
Temperature and pressure compensation
S)
2
13