Device Address And Id Number; Device Address; Id Number - PRONOVA SSM 6000 User Manual

Description
PROFIBUS interface
4

Device address and ID number

4.1

Device address

The device address is used to distinguish between the different devices within a Profibus network. Each device must have a distinct
address and all devices must have different addresses. Address changes via the Profibus in the "Wait-Parameter" (WPRM) state are
currently not supported by the SSM6000.
The default device address of the SSM6000 is device address "110". This setting can be varied between the values "1" and "126"
via the device control menu. For this purpose, turn the key-operated switch on the front panel of the device clockwise until the
display shows "SETUP MODE". You can then use the "down" key in order to move the flashing cursor to the "MODE" selection.
Thereafter, press the <Enter> key to confirm. The "DEVICE ID" menu is accessed in the same manner. The "_PROFIBUS" and
"_CANBUS" options are offered. Move the flashing cursor to the "_PROFIBUS" option and press the <Enter> key to confirm. You
can then use the "up" and "down" keys in order to set the desired device address. As soon as the cursor is once again positioned in
front of the "_PROFIBUS" selection parameter, the Profibus is re-initialized with the changed address and then communicates under
this address.
4.2

ID number

The ID number of the device is fixed and cannot be varied from outside. The number is assigned by the Profibus organization or can
be freely selected by the manufacturer. The Profibus DP slave accepts only those parameterization telegrams where the ID number
transmitted is identical to its own ID number. The ID number is known to the Profibus master from the GSD (device master data) file.
The ID number of the SSM6000 it 0AFFE
:GA-Profibus_060105-EN-pro.doc
.
h
Page 12 of 15 05.01.2006