ATTO Technology FastStream VT 5700 Installation And Operation Manual page 62

SESIdentify
Tells the appropriate SES enclosure to identify the
specified element(s). ALL identifies all disks. RAID
GroupName identifies all disks in a RAID Group. If the
MemberIndex is also specified, only that disk is identified.
ENC and enclosure index identifies all slots in the
specified enclosure. DRIVE BlockDevID identifies the
specified disk.
Note
The SESEnclosures command must be
executed before executing the SESIdentify
ENC or SESIdentify ALL command.
set SESIdentify [ALL | RAID GroupName
<MemberIndex> | ENC EnclosureIndex | DRIVE
BlockDevID]
get SESIdentify [ALL | RAID GroupName
<MemberIndex> | ENC EnclosureIndex | DRIVE
BlockDevID]
SESIdentifyStop
Tells the appropriate SES enclosure(s) to stop identifying
the specified element(s). If the MemberIndex is specified,
only that disk is identified. DRIVE and BlockDevID
identify the specified disk.
SESIdentifyStop [ALL |GroupName <MemberIndex> |
DRIVE BlockDevID]
SESMute
Causes the audible alarms for all known enclosures to be
muted or to use the remind state. The remind state
causes an occasional audible reminder, if supported by
the hardware, of the alarm condition.
Note
The command SESEnclosures must be
executed before executing SESMute.
Default: Mute
SESMute <EnclosureIndex> <remind>
SESPoll
Specifies the SES enclosure polling interval in seconds.
At the specified interval, all known SES enclosures are
polled for their current status. A setting of 0 disables SES
enclosure polling.
Default: 60
set SESPoll [0 | 30-3600]
get SESPoll
xxi
ATTO Technology, Inc. FastStream VT Installation and Operation Manual
SESStartingSlot
Establishes the starting slot/ID number for all attached
SES enclosures.
Default: 1
set SESStartingSlot [ 0 | 1]
get SESStartingSlot
SESStatus
Lists the last polled status of the specified element type in
the specified enclosure. Supported SES features include:
fan, power, temperature, alarm and drive LEDs. If no
element type is specified, the status of each is listed.
Note
The command SESEnclosures must be
executed before executing SESStatus.
SESStatus [EnclosureIndex] <ENC | DRIVES | FAN |
POWER | TEMP | ALARM | SUPPORTLEVEL>
SNTP
Controls whether an SNTP time server is used to set the
FastStream time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
SNTPServer
Controls or lists the main IP address the client uses to
retrieve the SNTP time.
Default: 192.43.244.18
set SNTPServer[xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get SNTPServer
TailEventLog
Lists new events to the terminal. Type quit and press
Enter to exit tail mode.
TailEventLog
TapeLibDelete
Deletes the specified tape library or all tape libraries.
TapeLibDelete [GroupName | all]
TapeLibInfo
Lists information for the specified tape library or all tape
libraries.
TapeLibInfo [LibName | all]