Install The Faststream Vt; Verifying The Contents Of The Packing Box; Installing The Faststream; Installing Windows Drivers - ATTO Technology FastStream VT 5700 Installation And Operation Manual

If you have not already completed the instructions on the Getting Started manual packed with your FastStream
VT, use the following instructions to install the FastStream VT.

Verifying the contents of the packing box

• The FastStream. Note the serial number of your
FastStream unit: ________________________
• Power cord
• "L" brackets for mounting in a 19" rack
• CD which includes the Firmware, Installation
and Operation Manual, QuickNAV IP discovery
program and system drivers

Installing the FastStream

1 Place the FastStream VT on a stable flat
surface or install it into a standard rack.
If installing into a rack (see
a. Attach "L" brackets so that the front side
with the LEDs face front and the connector
side is at the back.
b. Install the FastStream horizontally within
the rack so it does not reduce the air flow
within the rack.
2 Attach the appropriate cables.
a. Using SFPs and multimode fiber optic
cables, connect the FastStream Fibre
Channel ports 1 and 2 to your host
computer and ports 3 and 4 to your devices
(see Exhibit 1.1-1
b. Power up the devices.
3 Connect the Ethernet port to your network.
4 Connect the AC power cord from the
FastStream to the proper AC source outlet.
If you are using a rack:
a. Properly ground the FastStream to the rack
equipment. The earth ground connection
must be maintained.
b. The power requirements plus the power
draw of the other equipment in the rack
must not overload the supply circuit and/or
wiring of the rack.
5 Use the power switch and switch on power to
the FastStream.
6 Wait for the FastStream Ready LED to light
indicating the FastStream has completed its
power-on self test sequence.
®
7 Windows users continue to
Windows drivers. Mac
Discovering the IP

2.0 Install the FastStream VT

Exhibit 2.0-1):
on page 4).
Installing
®
users continue to
address.

Installing Windows drivers

1 Windows automatically detects the FastStream
and ask for the driver in the Add Hardware
wizard. select Install from a list or specific
location.
2 Click Next.
3 Choose Don't Search.
4 Click Next.
5 Choose Have disk.
6 The VT media changer and the VT tape have
separate driver files. Repeat the following steps
for each driver.
a. Specify the driver as found in the
VTMediaChanger or VTTapeDrive folder
in the setup CD. The files are in a folder
based on your operating system: Win2K
drivers for Windows 2000 and Windows XP
and Win2K3 drivers for all 2003 Server
products.
Note
Use the files directly from the CD or copy them
onto a floppy or to a local directory on your
hard drive.
b. Follow the remaining instructions to
complete the installation procedure.
7 After the driver for each device is installed, the
tape drive is listed under Tape Drives and the
VT media changer is listed under Media
Changer in the System Devices folder.

Discovering the IP address

Note
The FastStream VT is initially configured with
DHCP enabled. It is best if you have access to
a DHCP server.
1 Work from the computer attached to the
FastStream VT Ethernet port on the same
broadcast domain. From the CD supplied with
your FastStream, run the QuickNav Utility
QuickNAV-windows.exe for Windows or
QuickNAV-Mac for Mac OS X.
2 Locate the FastStream with the serial number
recorded earlier.