After Creating Raid Groups - ATTO Technology FastStream VT 5700 Installation And Operation Manual

After creating RAID groups

1 If you are not already in the ExpressNAV VTL
Manager, type the IP address of your
FastStream in a standard browser. On the
splash screen, click Enter Here. In the box
provided , type in your user name and
password, and click OK .
2 Click Diagnostics on the left side of the
ExpressNAV VTL Manager.
3 Select either I nitialize and Verify Drives or
Read-Only Drive Test from the Select User
Process menu.
4 Click Next.
5 If no drives appear in the information box, click
System Scan .
If drives are available, select the drives you
wish to verify, initialize or test. The drives are
highlighted.
6 Click Commit .
CAUTION CAUTION
Do not restart the FastStream or
disconnect or power cycle drives during
Drive Initialization and Verification or you
must start the verification process from the
beginning.
7 A warning box appears. In the warning box,
verify that you want to complete the
configuration by selecting Yes . Selecting No
ends the procedure without making a change.
8 If you chose to initialize and verify drives, the
Health and Status Monitor page appears and
all data on the previously-highlighted drives has
been erased.
If you chose to do a read-only test, the Drive
Performance and Health page appears listing
which tests are running and the test results.
You may select other tests to run or continue on
to other tasks.
8