ATTO Technology FastStream VT 5700 Installation And Operation Manual page 56

EventLog
When enabled, records various system events and errors
to the event log.
Default: enabled
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
Filters data from specific unit subsystems and levels
when event logging is enabled. The specific entries
supported are platform-dependent.
Default: all all all
set EventLogFilter [subsys | all] [event level | all] [all |
none]
get EventLogFilter [subsystem | all] [level | all]
Exit
Ends the current Ethernet telnet CLI session. It has no
effect if used during a serial CLI session.
Exit
FCConnMode
Controls/reports the connection mode the FastStream
uses when communication across a FC network, either to
a Fibre Channel Arbitrated Loop (FC-AL) when you select
loop mode, or point-to-point when you choose ptp. If
you choose loop-ptp or ptp-loop, the FastStream tries
to use the first parameter first.
Default: loop
set FCConnMode [fp] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration Restart command
get FCConnMode [fp | all ]
FCDataRate
Specifies the rate the FastStream uses, 1 Gigabit/sec., 2
Gigabit/sec. 4 Gigabit/sec. or auto negotiate.
Default: auto
set FCDataRate [fp |all ] [1Gb | 2Gb | 4Gb | auto]
Requires a SaveConfiguration Restart command
get FCDataRate [fp | all ]
FCHard
Used to enable or disable FC hard address assignment.
Under soft addressing, the FastStream loop address is
assigned during loop initialization.If you enable hard
addressing use FCHardAddress (described below).
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration Restart command
get FCHard
xv
ATTO Technology, Inc. FastStream VT Installation and Operation Manual
FCHardAddress
Sets/lists the value used as the FC-AL hard address. This
hexadecimal value represents the address the
FastStream tries to use if hard addressing is enabled.
When an address is not set, the current value is listed.
The valid range of values is 0 through 125.
Default
fp1=3, fp2=4
set FCHard Address [fp | [address]]
Requires a SaveConfiguration Restart command
get FCHardAddress [fp | all ]
FCMultiNode
When enabled (multi node), each port reports a separate
unique Node Name and logical units may be mapped to
any port. When disabled (single node), each port reports
the same Node Name and each logical unit map is
applied to all ports.
Note
Changing the state of this parameter deletes
all existing maps. Add new maps using the
AutoMap or Route
Default: disabled
set FCMultiNode [enabled | disabled]
Requires a SaveConfiguration command
get FCMultiNode
FCPortErrors
Lists the number of Fibre Channel errors that have
occurred since the last reboot/power-on or use of the
ResetFCPortErrors command.
get FCPortErrors
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are Up, Down, Failed,
Reserved and Disabled.
FCPortList
FCTargets
Lists all target devices available on the Fibre Channel port
with the index specified by fp. If no port index is specified,
all target devices on all Fibre ports are listed. A port-
unique index is assigned to each target which is used with
the fp to specify a Fibre Channel target for a subsequent
Route CLI command.
FCTargets <fp>
commands.