ATTO Technology FastStream VT 5700 Installation And Operation Manual page 57

FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 3 bytes of the WWN are used as the
Ethernet MAC address. The lower nibble of the highest
byte designates the port number.
get FCWWN [fp | all ]
FirmwareRestart
Resets and reinitializes the unit firmware. Use the
forced option to override any CLI reservations held by
other sessions.
FirmwareRestart <forced>
Help
Lists available commands. If command name is specified,
lists detailed command-specific information.
Help <command name>
HSAdd
Assigns a block device to the Hot Spare pool.
HSAdd [BlockDevID]
HSDisplay
Lists all devices in the Hot Spare pool.
HSDisplay
HSRemove
Removes a block device from the Hot Spare pool
HSRemove [BlockDevID]
IdentifyBridge
Enabling this option causes the front panel Ready LED of
the FastStream to blink until the parameter is disabled.
Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Lists version numbers and other production information
for key components.
Info
IPAddress
Regulates the current FastStream IP address.If
is enabled (see below), get command reports the current
IP address assigned by the network DHCP server.
Default IP Address: 10.0.0.1
set IPAddress [mp1] xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPAddress [mp1]
IPDHCP
Selecting DHCP allows the FastStream to request an IP
address from the network. The network must have at
least one DHCP server.
Default: enabled
set IPDHCP [mp1] [enabled | disabled]
Requires a SaveConfiguration Restart command
get IPDHCP [mp1]
IPDNSServer
Controls the current DNS Server address. If
enabled, the DNS Server address is automatically
detected. If IPDHCP is disabled, you must set the
address manually using this command.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
Controls the current default gateways used by the
Ethernet port on the unit. If
command reports the current IP gateway assigned by the
network DHCP server.
Default: 0.0.0.0
set IPGateway [mp1] [xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get IPGateway [mp1]
IPSubnetMask
Sets/lists the current subnet mask. If
enabled, get command reports current subnet mask
assigned by DHCP server.
Default: 255.255.0.0
set IPSubnetMask xxx.xxx.xxx.xxx
Requires a SaveConfiguration Restart command
get IPSubnetMask
IsReserved
Lists the reservation status of the FastStream.
IsReserved
MaxOpTemp
Regulates the maximum operating temperature of this
unit in degrees Celsius. Valid entries are between 55° C
°
and 70 C.
Default: 70
IPDHCP
set MaxOpTemp [55 – 70]
Requires a SaveConfiguration Restart command
get MaxOpTemp
IPDHCP
IPDHCP is enabled, the get
IPDHCP is
is
xvi