Replacing The Front Panel Foil - Weinmann homecare SOMNOcomfort 2 Servicing And Repair Instructions

3. Reattach the flat wires of front panel foil and
display to the main circuit board:
– Pull the lock.
– Insert the flat cable into the connector.
– Push the lock back in.
4. Connect plugs
X200
circuit board.
5. Close the unit (chapter 7.5, page 24).
6. Check that everything is working properly
(chapter 5., page 15).

7.7 Replacing the front panel foil

1. Open the unit (chapter 7.4, page 23).
2. Remove the main circuit board (chapter 7.6,
page 25, steps to
1.
3. Loosen the front panel foil
remove it.
4. Degrease this section of the housing using a
70 % Isopropanol solution.
5. Attach a new foil
52
Make sure the flat cable is inserted into the
corresponding opening of the housing cleanly
without any kinks.
6. Remove the protective foil from the new front
panel foil.
7. Insert the main circuit board (chapter 7.6,
page 25, steps to
1.
8. Close the unit (chapter 7.5, page 24).
9. Check that everything is working properly
(chapter 5., page 15).
26
Repair information and repair instructions
and to the main
X400
).
5.
using a knife and
52
to the housing.
).
4.
SOMNObalance/SOMNObalance e
X400
45
Flat cable
52
X200
44
Lock