Filter Change - Weinmann homecare SOMNOcomfort 2 Servicing And Repair Instructions

3.2 Filter change

1. In order to prevent water from entering the
SOMNOcomfort 2/SOMNOcomfort 2e/
SOMNObalance/SOMNObalance e,
detach the humidifier
doing so, please refer to the included
instructions for use.
2. Remove the filter compartment
rear of the unit.
3. Remove the coarse dust filter
4. Remove the fine dust filter
5. Replace the filters and close the cover on the
rear of the unit.
6. Attach the humidifier where applicable. Please
refer to chapter "3.4 Humidifier" of the
instructions for use.
Clear the filter change indicator:
– When switching the unit on, press and hold
the on/off switch
19
indicator goes blank.
Reset the hours meter
If the fine filter was changed due to soiling before
250 operating hours, the hours meter must be reset
to zero. Proceed as follows:
1. When switching the unit on, press and hold
the on/off switch
19
The filter change indicator will come on after
about three seconds before going off again
after another three seconds.
2. Release the on/off switch.
from the unit. When
4
cover on the
22
.
68
.
67
until the filter change
.
22
67 68
19
11
Servicing