Restore The Factory Default Configuration - Oracle SL150 Library Manual

Optionally, select Set the Library back Online to automatically bring the library
5.
online after the test (the library goes offline to perform the self test)
Click OK to start the test.
6.
If you did not check the Set the Library back Online checkbox, remember to
7.
bring the library back online manually, once you are ready. See
Online or

Restore the Factory Default Configuration

Restore the library to factory defaults settings to erase the existing configuration.
Record any important library configuration information because restoring will erase all
configuration information. Only reset the configuration as a last resort.
This procedure requires two people. One person at the front of the library and one
1.
at the rear. A single person cannot reach both buttons simultaneously.
Find the locator buttons — front upper left and rear top center (see below)
2.
Push and release either one of the locator buttons.
3.
Once the locator buttons light, simultaneously push and hold both front and rear
4.
buttons for about 10 seconds until the lights rapidly flash.
take significant time depending on the number of modules in the library, so
plan accordingly.
Note:
If the test fails, click Degraded to open a health table identifying a failed
or degraded component. See
Issue more information.
Offline.
Use the Health Table to Diagnose the
Chapter 9
Troubleshoot the Library
Place the Library
9-12