KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 50

Step 20: Attach Flange Assembly to Fort
Part 1
A: With a helper place the Flange Assembly flush to the top opening in (040) SL Panel as shown in fig. 20.1,
then pre-drill 1/8" pilot holes in the bottom 4 mounting locations (approximate spots where circles are on
figure), making sure the pre-drilled holes are a minimum of 2.5 cm (1") deep. (fig. 20.2)
B: Attach Flange Assembly to bottom of (040) SL Panel opening using 4 (S7) #12 x 2" Pan Screws (with #12
Screw Bezel) in the pre-drilled holes. (fig. 20.2) Make sure the flat surfaces of the Flange Assembly are flush
to the (040) SL Panel as shown in fig. 20.3.
C: Attach the Flange Assembly flush to top of (040) SL Panel opening using 4 (S6) #12 x 1" Pan Screws (with
#12 Screw Bezel) as shown in fig. 20.2 and to both sides using 5 (S6) #12 x 1" Pan Screw per side. (fig. 20.2)
Fig. 20.2
Flange
Inside View
Assembly
Side
Bottom
Top
040
S6
w/ #12 Screw
Bezel
S7
w/ #12 Screw
Bezel
Hardware
14 x #12 x 1" Pan Screw
S6
4 x #12 x 2" Pan Screw
S7
8 x #12 Screw Bezel
50
Fig. 20.1
Outside View
Side
Flange
Assembly
Side
Bottom
S6
040
(5 per side)
Fig. 20.3
Top
Side
Top of (040) SL
Panel opening
Bottom of
slide flush
with bottom
of opening