KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 24

Step 5: Swing Wall Assembly
A: Place (051) Front Wall Panel against the left side of (050) SW Panel noticing panel orientation. The tops and
bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (051) Front
Wall Panel to (050) SW Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 5.1 and 5.2)
B: Place (052) Back Wall Panel against the right side of (050) SW Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (050)
SW Panel to (052) Back Wall Panel to with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 5.1 and 5.3)
Fig. 5.2
Flush
051
Notice (051) Front Wall
Panel overlaps (050)
SW Panel
WL5
Wood Parts
1 x SW Panel 1-1/4 x 42 x 87"
050
1 x Front Wall Panel 1-1/4 x 42 x 87"
051
1 x Back Wall Panel 1-1/4 x 42 x 87"
052
050
Fig. 5.1
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
052
24
Fig. 5.3
Flush
050
Notice (050) SW Panel
overlaps (052) Back
Wall Panel
WL5
050