KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 21

Step 3: Rockwall Assembly
Part 1
A: Place (030) Access Board flush to the top of the Access Ladder/Rockwall Assembly and (031) Wall Board flush
to the bottom of the assembly as shown in fig. 3.1. Then place (032) Rock Board A and (033) Rock Board B as
shown in fig. 3.1. Do not screw boards down yet. Rock holes are to be staggered so they do not form a straight
line and are at the top of the boards. Note: Rock Boards are to be flush to (020) Left Access and pilot holes
are centred over (024) Rock Rail. (fig. 3.1)
B: Make sure all boards are tight together and the assembly is square, then attach all boards except for (030)
Access Board using 4 (S2) #8 x 1-1/2" Wood Screws per board. (030) Access Board to be attached in Step 10,
Part 2, keep aside until needed. (fig. 3.1)
Do not attach yet,
030
put aside until
Step 10
Flush
S2
x 4 per
board
Wood Parts
1 x Access Board 1 x 6 x 19-3/4"
030
1 x Wall Board 1 x 5 x 19-3/4"
031
4 x Rock Board A 1 x 6 x 19-3/4"
032
4 x Rock Board B 1 x 6 x 19-3/4"
033
Fig. 3.1
032
033
033
032
IMPORTANT!
Follow hole
pattern
36 x
033
032
032
Hardware
#8 x 1-1/2" Wood Screw
S2
21
033
031
024
Flush
020