KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 44

Step 15: Swing End Assembly
A: Loosely attach 2 (150) Heavy SW Posts to (151) SW Upright using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with lock
washer, flat washer and t-nut). Notice 2 bolt holes at top of (151) SW Upright and orientation of angle. (fig.
15.1)
B: Attach (152) SW Support to both (150) Heavy SW Posts and (151) SW Upright using 3 (G4) 5/16 x 4" Hex
Bolts (with lock washer, flat washer and t-nut). Tighten all bolts. (fig. 15.1)
C: Install 2 (WB7) 5/16 x 3" Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (151) SW Upright
as shown in fig. 15.1. IT IS IMPORTANT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Fig. 15.1
150
Wood Parts
2 x Heavy SW Post 2 x 3 x 86-11/16"
150
1 x SW Upright 4 x 4 x 50-15/16"
151
1 x SW Support 5/4 x 4 x 46-1/2"
152
5/16"
T-Nut
152
5/16" Flat
Washer
5/16" Lock
Washer
2 x
G7
3 x
G4
2 x
WB7
151
G4
Hardware
5/16 x 5-1/2" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
5/16 x 4" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
5/16 x 3" Wafer Bolt (5/16" flat washer & 5/16" t-nut)
44
WB7
5/16"
T-Nut
G7
5/16" Lock
5/16" Flat
Washer
Washer
5/16" Flat
Washer
Notice 2 bolt
holes at top and
orientation of
the angle
5/16"
T-Nut