KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 23

Step 4: Slide Wall Assembly
A: Place (041) Back Narrow Panel against the left side of (040) SL Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (041)
Back Narrow Panel to (040) SL Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 4.1 and 4.2)
B: Place (042) Front Narrow Panel against the right side of (040) SL Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (040) SL
Panel to (042) Front Narrow Panel to with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 4.1 and 4.3)
Fig. 4.2
Flush
041
Notice (041) Back
Narrow Panel overlaps
(040) SL Panel
Wood Parts
1 x SL Panel 1-1/4 x 42 x 87"
040
1 x Back Narrow Panel 1-1/4 x 22 x 87"
041
1 x Front Narrow Panel 1-1/4 x 22 x 87"
042
Fig. 4.1
040
WL5
8 x
040
Hardware
1/4 x 2-1/2" Wafer Lag
WL5
23
Fig. 4.3
042
Notice (040) SL Panel
overlaps (042) Front
Narrow Panel
WL5
Flush
Flush
040