KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 43

Step 14: Swing Beam Assembly
A: Attach 6 Swing Hangers to (140) Beam SW using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with 2 flat washers and 1
lock nut) per swing hanger, as shown in fig. 14.1.
B: Flush to the Fort Side end of (140) Beam SW attach 2 L-Beam Brackets with 2 (G21) 5/16 x 3-3/4" Hex
Bolts (with 2 flat washers and 1 lock nut). (fig. 14.2)
C: Install 1 (WB7) 5/16 x 3" Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (140) Beam SW
as shown in fig. 14.1 and 14.3. IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE
CHECKING OF WOOD.
D: Attach Cedar Summit Plaque to centre of (140) Beam SW (over top of t-nut) using 4 (S18) #6 x 1" Wood
Screws. (fig. 14.4)
Fort Side
Fig. 14.2
5/16"
Lock Nut
L-Beam
Bracket
Flush
L-Beam
Bracket
G21
Wood Parts
1 x Beam SW 4 x 6 x 88"
140
Swing Hanger x 6
Fort Side
5/16" Flat
Washer
140
5/16" Flat
Washer
5/16" Flat
Washer
12 x 5/16 x 5-1/2" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
G7
2 x 5/16 x 3-3/4" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
G21
1 x 5/16 x 3" Wafer Bolt (5/16" flat washer & 5/16" t-nut)
WB7
4 x #6 x 1" Wood Screw
S18
Fig. 14.1
Fig. 14.3
5/16"
T-Nut
Hardware
43
140
5/16"
Lock Nut
G7
S18
x 4
140
Cedar Summit
Plaque
WB7
Other Parts
6 x Swing Hangers
2 x L-Beam Bracket
1 x Cedar Summit Plaque
Swing Side
5/16" Flat
Washer
Fig. 14.4