KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 47

Step 18: Install Ground Stakes
A: In the 5 places shown in fig. 18.1 drive the Rebar Ground Stakes 33 cm (13") into the ground against (040) SL
Panel, on the Front, (091) Diagonal, (021) Right Access and both (150) Heavy SW Posts. Be careful not to hit the
washer while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 18.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
driven 33 cm (13") into ground. Digging or driving stakes can be dangerous if
you do not check first for under-ground wiring, cables or gas lines.
Fig. 18.1
040
Front
SEE FRONT COVER FOR
SAFETY CLEARANCE
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes must be
091
021
5 x
150
Hardware
#12 x 2" Pan Screw
S7
47
F
ig. 18.2
Rebar Ground
Stake
Other Parts
5 x Rebar Ground Stake
S7
33 cm (13")
In Ground