KidKraft Cedar Summit RICHMOND LODGE Installation And Operating Instructions Manual page 32

Step 9: Attach SW Ground and Diagonal
A: Loosely attach (090) SW Ground to (091) Diagonal with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock washer, flat
washer and t-nut) then place (091) Diagonal tight and flush to the front of (050) SW Panel. (090) SW Ground to
be flush to the bottom of (050) SW Panel. (fig. 9.1 and 9.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (091) Diagonal to (050) SW Panel with 1 (WL5) 1/4 x 2-1/2"
Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 9.1 and 9.2)
C: Making sure bottom of (090) SW Ground is flush to bottom of (050) SW Panel pre-drill with a 1/8" drill bit then
attach with 2 (S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 9.1 and 9.2)
Fig. 9.1
050
Wood Parts
1 x SW Ground 5/4 x 4 x 14-1/4"
090
1 x Diagonal 1-1/4 x 3 x 22"
091
050
090
S11
Flush
Hardware
1 x 1/4 x 2-1/4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H10
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
5/16" Flat
Washer
Flush
H10
S4
32
Fig. 9.2
WL5
091
1/4"
T-Nut
1/4" Flat
Washer
1/4" Lock Washer