Labconco SteamScrubber 4010010 Series User Manual page 99

Poor washing
results
Tank and inner door
have surface rust
Washer does not
run
Washer door opens
and closes badly
Washer leaks
Water is not hot
enough.
Improper loading
Detergent too old or
amount wrong.
Detergent caked in
D- Cup.
Insufficient wash
time.
Wash arms not
spinning.
Glassware
interfering with cup
door.
Glassware is
contaminated with
acids.
No power to washer.
Improper wiring
12 V power supply
Cabinet opening is
not square.
Door hitting counter-
top mounting
screws.
Door not sealing or
door too tight.
Improper detergent.
99
. Should be at least
Check Wash 120°F (49°C).
water temperature Recommended
setting temperature is
150°F (66°C).
instructions in
Check washer
Chapter 7 in this
loading
manual.
Replace detergent
or change quantity
used.
Clean D-Cup.
Replace with fresh
detergent. Check
water inlet
temperature.
Should be at least
120°F (49°C).
Increase wash cycle
time.
Remove and clean
wash arms.
Move glassware.
Pre-rinse glassware.
Clean with stainless
steel cleaner and
soft cloth.
Check fuse or circuit
breaker.
Check wiring to
Correct wiring
unit
If input OK and
Check power to
output 12VDC
and out of 12V
replace power
power supply.
supply
Correct opening with
leveling feet.
Adjust mounting
screws.
Adjust hinge pins or
door striker.
Use non-foaming
Check detergent detergent. Use only
for foaming. proper amount of
detergent.