Interrupting A Wash Cycle/Open Door - Labconco SteamScrubber 4010010 Series User Manual

Interrupting a Wash Cycle/Open Door

To temporarily pause a wash cycle, touch the
Reference Fig. 7-6. The wash cycle will stop. Press the Open button to open the door.
When opening the door, if the internal temperature is greater than 50°C, a warning
will display which requires confirmation before opening the door. Use extreme
caution, open the door slowly, hot steam will rise out of the washer which could
cause injury.
Lors de l'ouverture de la porte, si la température interne est supérieure à 50°C, un
avertissement s'affichera qui demandera la confirmation que vous voulez ouvrir
la porte. Faites preuve d'une extrême prudence, ouvrez la porte lentement, la
vapeur chaude s'élèvera de la laveuse qui pourrait causer des blessures.
If you press open while the cycle is running, the washer will prompt for confirmation to
pause the cycle. If confirmed, there will be a 7 second delay before the door unlocks.
To resume the wash cycle, close the washer door until latched. Touch the
and then confirm by touching [OK]. If the water temperature is greater than 50°C the
washer may pause for up to 2-1/2 minutes to equalize the internal temperature, after
which the cycle will resume the interrupted segment.
The wash cycle can be terminated at any time by touching the
touching [OK] on the confirmation pop-up.
CURRENT
PROGRAM
COMPLETED
SEGMENT
PAUSE
CANCEL
PROGRAM
SEGMENT
80
Pause Icon and select
Cancel
Figure 7-6
CHART
ACTIVE
SEGMENT
[OK] to confirm.
Start Icon
Icon, and then
SYSTEM
TEMPERATURE
CYCLE TIME
REMAINING
PROGRAM
PROGRESS
INDICATOR